ACMER
ACMER S2 20W Laser Engraver with Air Assist
Powder-coated tumblers on a roller rotary, names and logos on wood, leather and coated metal
A 10 W, 450 nm diode on a 300 × 300 mm frame — enough bed for a 5 × 7 blank and a test piece beside it, enough power for a photo in coated acrylic.
A photo engraving is thousands of dots, and the dots can only be as fine as the laser’s spot. A 10 W diode with a spot under a tenth of a millimetre is the class of machine that renders whiskers and the catchlight in an eye at 5 × 7 in, and its bed is the size this project needs: one blank for the real thing and one beside it for the test grid, with room left over.
The TTS-10 Pro is an open-frame machine, which is what makes it affordable and what makes the glasses and the ventilation below non-negotiable. It runs from LightBurn or LaserGRBL like any other diode, and it also runs a job from a TF card with no computer attached, which matters more than it sounds for a 40-minute photo.
Pro tip Export the finished job to the TF card and start it from the control board. A laptop that goes to sleep halfway through an engraving leaves a hard line across the picture, and a card in the slot can’t fall asleep.
Why we like it
Keep in mind
As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.
ACMER
Powder-coated tumblers on a roller rotary, names and logos on wood, leather and coated metal
Artliving
Displaying engraved coasters and small plaques, finishing the gift
ATOMSTACK
Cutting wood and acrylic on a diode laser that has an air-assist nozzle, cleaner engraving on wood
Brilliance Laser Inks
Bare or brushed stainless tumblers, flasks and tags on a diode or CO2 laser