ACMER
ACMER S2 20W Laser Engraver with Air Assist
Powder-coated tumblers on a roller rotary, names and logos on wood, leather and coated metal
A pump with a dial that blows a steady stream of air down the laser's nozzle, so smoke clears out of the cut instead of sitting in it.
Without air, a diode laser cutting plywood leaves a pool of smoke and burning resin in the kerf. The beam has to push through it, the edges come out black, and the flame sometimes keeps going after the head has moved on. Air assist blows a narrow stream straight down the nozzle, through the point where the beam hits, and pushes all of that out of the way.
The F80 makes the most sense for anyone who cuts more than they engrave. The dial matters: high flow helps a cut, but on a light engraving it can scatter ash across the surface, so a gentle setting is better there.
Pro tip Keep the flow low for engraving photos on wood and turn it all the way up only for cuts. If an engraving looks dusty or streaky, lower the air before you change any laser settings.
Why we like it
Keep in mind
As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.
ACMER
Powder-coated tumblers on a roller rotary, names and logos on wood, leather and coated metal
Artliving
Displaying engraved coasters and small plaques, finishing the gift
Brilliance Laser Inks
Bare or brushed stainless tumblers, flasks and tags on a diode or CO2 laser
CARLANY
Blue diode laser engravers (445–455 nm), a pair for each person in the room