Kraang Finds
More ▾
Products About
Electronics TUOFENG

TUOFENG 22 AWG 2-Conductor Red/Black Wire, 100 ft

Joined red and black wire for the hidden jumps between letters, with + and − always easy to tell apart.

Warm-white DIY neon rope sign glowing on a clear acrylic panel above a shelf, with neon tube and remote on a table
Best for Jumper wires between LED and neon sections12/24 V LED wiringsmall electronics

A neon sign is rarely one continuous line. Where the light has to jump from the end of one letter to the start of the next, the tube is cut and the two pieces are joined behind the panel with a short pair of wires. Red and black cable that stays together makes those jumpers neat and keeps polarity mistakes away.

22 AWG is a comfortable size for this: thin enough to solder onto the small pads inside a neon tube, and well above the current of a sign a few feet long, which is usually a fraction of an amp per section.

Pro tip Cut every jumper a little longer than the path behind the panel and tin both ends before you solder. Then test the section with power before you seal the joint; a dead letter is much easier to fix while the end is still open.

Why we like it

  • ✓Red and black joined in one cable — polarity is obvious at every joint
  • ✓Stranded tinned copper, flexible and quick to solder
  • ✓The two conductors pull apart where you need them separate
  • ✓100 ft spool, enough for many signs and strip projects

Keep in mind

  • !PVC jacket rated to 80 °C (176 °F), softer and less heat-proof than silicone wire
  • !100 ft is far more than one sign needs
Gauge
22 AWG
Conductors
2 (red, black), parallel
Strands
17, tinned copper
Insulation
PVC, 300 V, 80 °C
Length
100 ft
Max current
3.5 A, per listing

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Electronics