Kraang Finds
More ▾
Products About
Electronics ALITOVE

ALITOVE 5 V 10 A Power Supply Adapter (50 W)

A closed plug-in brick that gives the panel and the ESP32 one clean 5 V supply, with no mains wiring to do yourself.

A DIY pixel LED panel behind frosted acrylic showing a pixel Christmas tree and snowfall on a shelf, filmed by a phone on a tripod
Best for WS2812B panels and strips5 V LED projectssmall 5 V electronics

An open-frame industrial supply has more headroom, but it means wiring mains voltage to screw terminals and building a cover for it. For a panel that sits on a shelf or goes to someone as a gift, a closed adapter is the safer shape: the only connection you make is on the 5 V side.

Ten amps covers the panel, the ESP32 and a safety margin, as long as the brightness limit in the firmware stays below what the supply can deliver.

Pro tip Set the controller’s current limit to about 80 % of the supply’s rating (8 A here, or lower), and leave the brick in open air rather than stuffed behind the frame.

Why we like it

  • ✓5 V output at up to 10 A (50 W), enough for a 16 × 16 panel with its brightness capped
  • ✓Closed adapter with a detachable AC cord, so you never touch mains terminals
  • ✓Over-load, over-voltage, over-temperature and short-circuit cut-off, ALITOVE says
  • ✓Standard 5.5 mm barrel plug, center positive

Keep in mind

  • !The barrel plug needs a matching female jack or screw-terminal adapter to connect to bare wires
  • !Listing names CE, FCC and RoHS but no UL or ETL listing
Input
100–240 V AC, 50/60 Hz
Output
5 V DC, 10 A max (50 W)
Plug
5.5 mm outer, 2.1–2.5 mm inner, center positive
Weight
300 g
Model
J200-05010000

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Electronics