ACMER
ACMER S2 20W Laser Engraver with Air Assist
Powder-coated tumblers on a roller rotary, names and logos on wood, leather and coated metal
A 12 in wide roll of paper transfer tape that makers lay over wood as a laser mask, so smoke stains peel off with the paper.
Engraving hardwood throws off smoke and resin, and some of it settles around the letters as a yellow-brown halo. On a pale maple board that halo is what makes an engraving look homemade. A layer of paper tape on the board before the laser runs catches it instead: the laser burns through the paper where the design is, and everything else peels off clean afterwards.
Transfer tape for vinyl is the usual choice because it comes in wide rolls and its adhesive lets go without leaving residue. That’s not what TapeManBlue makes it for, but it’s what many laser makers use it for.
Pro tip Lay the tape with a squeegee or a credit card from the center out, then burnish it down hard over the area to be engraved. Any air bubble lifts during the job, and the edge of a lifted bubble shows up as a smudge on the wood.
Why we like it
Keep in mind
As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.
ACMER
Powder-coated tumblers on a roller rotary, names and logos on wood, leather and coated metal
Artliving
Displaying engraved coasters and small plaques, finishing the gift
ATOMSTACK
Cutting wood and acrylic on a diode laser that has an air-assist nozzle, cleaner engraving on wood
Brilliance Laser Inks
Bare or brushed stainless tumblers, flasks and tags on a diode or CO2 laser