Kraang Finds
More ▾
Products About
Electronics Seeed Studio

Seeed Studio XIAO ESP32-C6 (Pre-Soldered)

A thumb-sized Wi-Fi 6 board with the pins already soldered — reads the level sensor, runs the pump and reports to your phone.

DIY auto-topping pet water bowl with a sensor, clear reservoir and small pump, a cat drinking
Best for Small Wi-Fi and Home Assistant buildssensor-and-switch projectsZigbee and Thread experiments

An auto-topper needs a brain that does three small things reliably: read one sensor, switch one pump, and tell you when something goes wrong. The XIAO ESP32-C6 has the Wi-Fi for the last part and enough spare pins for the first two, on a board smaller than a postage stamp that fits easily inside a printed electronics box.

This is the pre-soldered version, so you can build and test the whole circuit on a breadboard first and only then move it into the enclosure. Seeed also lists support for Zigbee, Thread and Matter, which matters only if your smart home runs on those; a plain Wi-Fi sketch or ESPHome is the simpler start.

Pro tip Keep the board above the water line and away from the bowl, in a closed box with the cables leaving from the bottom. A loop in each cable below the box (a drip loop) keeps a stray drop from running along the wire into it.

Why we like it

  • ✓Pin headers come soldered on, so it plugs straight into a breadboard
  • ✓2.4 GHz Wi-Fi 6, Bluetooth LE, plus a radio for Zigbee and Thread
  • ✓Two RISC-V cores, a 160 MHz main core and a 20 MHz low-power core
  • ✓Tiny, 21 × 17.8 mm, with an onboard antenna and a U.FL connector for an external one
  • ✓Programs over USB-C from the Arduino IDE; also a common target for ESPHome

Keep in mind

  • !Its pins are 3.3 V only, so a 5 V sensor output needs a voltage divider
  • !Few pins in total; fine for a sensor and a pump, tight for a bigger build
  • !2.4 GHz only — the router's 2.4 GHz band has to reach the bowl
Chip
ESP32-C6, RISC-V, 160 MHz + 20 MHz low-power core
Wireless
Wi-Fi 6 (2.4 GHz), Bluetooth LE, 802.15.4 (Zigbee, Thread)
Flash
4 MB
Board size
21 × 17.8 mm
Headers
Pre-soldered
Connector
USB-C
Model
102010636-FA

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Electronics