Kraang Finds
More ▾
Products About
Laser Engraving ScotchBlue

ScotchBlue Original Painter's Tape 2090, 0.94 in × 60 yd

The blue tape that holds a blank square on the laser bed, marks a corner for the next one and shims a 3 mm sheet in a wider slot.

A clear acrylic pane in a wooden LED base glowing with a frosted laser-engraved portrait of a dog, next to a phone showing the same photo
Best for Fixturing blanks on an open-frame lasera corner guide for repeat positioningshimming acrylic in a light-base slot

An open-frame diode laser has no clamps and no honeycomb, just a bed, and a 5 × 7 blank sitting loose on it moves the first time the gantry bumps the bench. A strip of painter’s tape over each corner, outside the picture, holds it flat and still for the forty minutes a photo takes. Two more strips in an L make a corner guide, so the test piece and the real piece land in the same place and the test settings mean something.

The tape earns its second job at the end: wooden light bases are cut for a range of sheet thicknesses, and a 3 mm sheet can lean in a wider slot. A strip along each face of the bottom edge takes up the slack, hidden inside the slot, with the edge itself left bare for the light.

Pro tip Shim the faces, never the bottom edge. The LEDs shine up into that edge, and tape across it dims the whole picture; tape along the sides of the strip that sits in the slot is invisible and changes nothing.

Why we like it

  • ✓Medium-adhesion crepe paper that comes off acrylic and the laser bed without residue per 3M
  • ✓0.94 in wide — a strip across each corner holds a 5 × 7 blank flat and still for the test and the real run
  • ✓Two strips in an L on the bed make a corner guide, so the trial blank and the gift go in the same spot
  • ✓A strip along each face of the bottom edge turns a 3 mm sheet into a snug fit in a wider slot
  • ✓60 yd on the roll; a project uses a few feet

Keep in mind

  • !Paper chars where the laser crosses it, so it stays outside the engraving area
  • !3M's label says to remove it within 14 days, so it's a fixture, not a permanent shim on a finished piece
  • !Any painter's tape does these jobs; this is the known-quantity roll, not a specialty laser mask
Width
0.94 in (24 mm)
Length
60 yd (180 ft)
Material
Crepe paper, blue
Adhesive
Medium, no residue (per 3M)
Thickness
0.16 mm
Model
2090-24NC (3M)
Also on the listing
4-roll and 24-roll packs

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Laser Engraving