Kraang Finds
More ▾
Products About
3D Printing Rust-Oleum

Rust-Oleum 249415 Automotive Sandable Primer, Gray, 12 oz (2-Pack)

A gray spray primer that sands smooth — the step that turns visible layer lines into a painted-looking surface.

Painted 3D-printed Halloween mask with a moving jaw on a workbench next to servos, an Arduino board and a battery box
Best for Hiding layer lines on FDM printspriming props and masks before spray paint

FDM layer lines are hard to see on bare plastic and obvious under paint. A sandable primer fills the shallow grooves between layers; sanding it back leaves primer in the low spots and smooths the high ones. Two or three rounds of spray and sand take a print from “3D printed” to “cast”.

Gray is the useful color here. It’s neutral enough to show scratches, pits and seams, so you can fix them before the color coat makes them permanent.

Pro tip Spray light coats from about 10–12 inches (25–30 cm) and keep the can moving. One heavy coat runs, fills the details you modeled and takes far longer to cure.

Why we like it

  • ✓Wet- or dry-sandable, so you can sand it back between coats
  • ✓Dry to the touch and recoatable in 10 minutes, Rust-Oleum says
  • ✓Flat gray shows every remaining flaw before the color coat
  • ✓Two 12 oz cans — enough for several coats on a full mask

Keep in mind

  • !Oil-based spray with strong fumes — outdoors or in a well-ventilated space only
  • !Sold for wood, metal and fiberglass; test it on a scrap print before spraying the mask
Volume
2 × 12 oz (340 g)
Color
Gray, flat finish
Dry to touch
10 min (Rust-Oleum)
Coverage
Up to 15 sq ft per can
Type
Oil-based aerosol
Model
249415

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More 3D Printing