3DZWMAN
3DZWMAN LED Lamp Kit 001, 3 Pack (3 Colors, Dimmable, USB)
Lithophane lamps and shades, MakerWorld lamp models, giving three lamps at once
Square, clean cuts on PTFE tubing — the small detail that stops a lot of hotend clogs.
On a Bowden printer, the PTFE tube has to sit perfectly flat against the nozzle. A tube cut at a slight angle with a knife leaves a tiny gap where melted filament collects, and that’s a classic source of clogs and under-extrusion.
A tube cutter holds the tubing at a right angle and cuts it in one squeeze, so the end is square and clean. It’s a small tool you won’t use every week, but when you replace a tube, you want it.
Pro tip When you swap the PTFE tube, push it down firmly so it sits against the nozzle, and hold it there while you lock the coupling clip. A tube that springs back even a millimeter leaves the same gap.
Why we like it
Keep in mind
As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.
3DZWMAN
Lithophane lamps and shades, MakerWorld lamp models, giving three lamps at once
3M
Sanding primer on 3D prints, smoothing between paint coats, small prop and model work
Amazon Basics
Powering USB lamps and LED strips, two lamps from one outlet, gifts that need their own plug
Americanflat
Housing a layered map light, framed lithophanes, backlit layered art