Kraang Finds
More ▾
Products About
3D Printing PAUTIX

PAUTIX USB COB LED Strip, 3000K Warm White, 6.56 ft

A dotless warm-white strip for lighting a lithophane box or frame evenly, without bright LED spots behind the photo.

Photo of a dog on a phone next to a glowing 3D-printed lithophane lamp showing the same dog
Best for Lithophane light boxes and framescustom-size lampsshelf lighting

Not every lithophane fits a round lamp base. A flat panel in a frame, a box-shaped night light or a wide landscape photo needs light spread along the edges instead. A COB strip is a good fit: the LEDs are packed so tightly that it glows as one line, so you don’t get bright dots showing through the thin parts of the photo.

Stick the strip around the inside of a printed light box, leave a gap of an inch or more to the lithophane, and the light evens out before it reaches the print.

Pro tip Line the inside of the box with white (print it in the same white PLA or tape in white paper). The light bounces around before it hits the lithophane, and the photo glows evenly from corner to corner.

Why we like it

  • ✓COB strip — a continuous line of light instead of separate dots
  • ✓3000K warm white with CRI above 90
  • ✓10-level dimmer that remembers the last setting
  • ✓5 V USB, with 3M adhesive backing

Keep in mind

  • !Needs a USB port that gives at least 2 A, or it flickers or switches off, PAUTIX says
  • !6.56 ft is far more than one small box needs
Length
6.56 ft (2 m)
LEDs
640 (320 per m)
Color temperature
3000K
CRI
>90
Power
5 V USB, 8 W
Dimmer
10 levels, with memory
USB cable
2.6 ft

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More 3D Printing