Kraang Finds
More ▾
Products About
Laser Engraving Mr. Clean

Mr. Clean Magic Eraser Extra Durable, 12 Count

Melamine foam pads that work with just water — makers use them to lift the gray haze of burnt powder coat out of a fresh engraving.

A black powder-coated tumbler laser-engraved with a name in bright steel, beside a second tumbler on a roller rotary under an open-frame diode laser
Best for Cleaning residue from engraved powder-coated tumblerssmoke marks around engravingsgeneral shop cleanup

When the laser strips powder coat, some of the burnt coating settles back as a gray or brown film on the bare steel and the edges of the lines. It wipes off, but a cloth tends to skate over the narrow grooves. A damp melamine pad reaches into them and lifts the film without any cleaner on the coating.

Light pressure is enough. The aim is a bright steel line with crisp edges; scrubbing hard only risks wearing a shiny patch into the matte coat around it.

Pro tip Cut a pad into four small blocks. A corner of a small block fits the letters and lasts longer than working with the whole pad, and the rest stay dry for the next tumblers.

Why we like it

  • ✓Works with water alone, so no solvent touches the powder coat
  • ✓Melamine foam gets into engraved lines that a cloth slides over
  • ✓The Extra Durable version is made to crumble less, per Mr. Clean
  • ✓12 pads, enough for a batch of tumblers and the shop's other messes

Keep in mind

  • !Melamine is a fine abrasive — it can dull a glossy powder coat, so test it on the bottom of the cup first
  • !Not for the clear plastic lid, which it can haze
  • !Each pad wears down as it's used
Material
Melamine foam
Count
12 pads
Use
Wet with water, squeeze, wipe
Scent
Unscented

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Laser Engraving