Kraang Finds
More ▾
Products About
Laser Engraving LONGER

LONGER Ray5 10W Laser Engraver, 400 × 400 mm

An open-frame 10 W diode with a 400 × 400 mm work area and a touchscreen — raise it on blocks and a thick board slides right under.

A maple cutting board laser-engraved with a family name and freshly oiled, with a raised open-frame laser engraver behind
Best for Engraving cutting boards and other thick blanksnames and logos on woodfirst diode laser

An engraved name on a cutting board doesn’t need photo-level detail, but it needs clean edges and enough power to burn a deep, even brown into hard maple. A 10 W diode does that in one or two passes, and the 400 × 400 mm working area covers a design across the middle of a full-size board.

The real reason to pick an open frame for this project is height. A cutting board is 1 in thick or more, which is taller than many enclosed machines accept. The Ray5 sits on four feet over the work, so it can stand on blocks, the board slides underneath and the focus is set on the board’s surface. The trade-off is safety gear and fresh air: an open diode laser needs both.

Pro tip Raise all four feet by exactly the same amount (identical wood blocks or a set of risers), then frame the job before engraving. A machine that’s tilted by even a few millimetres engraves one end of a long name sharper than the other.

Why we like it

  • ✓10 W dual-beam diode module with a 0.06 × 0.06 mm spot for clean lettering
  • ✓400 × 400 mm (15.7 × 15.7 in) working area, enough for a design across most of a cutting board
  • ✓Open frame, so a board thicker than the frame's clearance can go under a raised machine
  • ✓3.5 in touchscreen plus USB, TF card and Wi-Fi, so a job can run without a laptop attached
  • ✓Works with LightBurn and LaserGRBL as well as LONGER's own LaserBurn software
  • ✓Emergency stop, motion protection and overheat detection per LONGER

Keep in mind

  • !Class 4 open frame — everyone in the room needs laser glasses rated for the blue diode, and it must never run unattended
  • !No enclosure or fume extraction; smoke needs a window and a fan
  • !Comes as a kit to assemble, and has no camera or auto-focus — focus is set by hand for every piece
Laser
10 W optical, dual-beam blue diode
Spot size
0.06 × 0.06 mm
Working area
400 × 400 mm (15.7 × 15.7 in)
Max speed
24,000 mm/min
Control
3.5 in touchscreen, USB, TF card, Wi-Fi, app
Software
LightBurn, LaserGRBL, LaserBurn
Weight
9.4 lb (4.3 kg)
Model
Ray5 10W

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Laser Engraving