Kraang Finds
More ▾
Products About
Electronics Lesnlok

Lesnlok Translucent White Acrylic Sheet, 8 × 12 in (2-Pack)

A milky white cast acrylic front that blends 256 bright dots into soft squares of color.

A DIY pixel LED panel behind frosted acrylic showing a pixel Christmas tree and snowfall on a shelf, filmed by a phone on a tripod
Best for LED panel diffuserslight boxeslamp shadeslaser-cut signs

Lesnlok sells the same sheet in an opaque white version that lets only a few percent of the light through. For an LED panel you want this translucent one: bright enough to show colors well, cloudy enough to blend the pixels.

A sheet this size cuts into one front panel with plenty left over. Score it several times along a straightedge with a plastic-cutting knife, then snap it over the edge of the bench.

Pro tip Put the matte side toward the viewer. It hides fingerprints and reflections, which matters a lot when the panel ends up on camera.

Why we like it

  • ✓Translucent matte white, around 73 % light transmission, Lesnlok says
  • ✓Cast acrylic, 1/8 in (3 mm) thick, with protective film on both sides
  • ✓8 × 12 in sheet covers a 16 × 16 cm panel with room for a frame edge
  • ✓Two sheets, so a cutting mistake isn't the end of the project

Keep in mind

  • !Scratches easily once the film is off; keep the film on until assembly
  • !Too clear to hide the LEDs if it sits directly on the panel; it needs a small air gap
Size
8 × 12 in (about 20 × 30 cm)
Thickness
1/8 in (3 mm)
Material
Cast acrylic
Finish
One side matte, one side glossy
Pieces
2

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Electronics