ACMER
ACMER S2 20W Laser Engraver with Air Assist
Powder-coated tumblers on a roller rotary, names and logos on wood, leather and coated metal
Clear, odorless mineral oil — one wipe takes slate to deep black and brings up the tones of a wood engraving.
Straight off the laser, slate looks dusty gray and a wood engraving looks a little flat. Mineral oil is the one-minute fix for both. On slate it soaks into the stone and turns the untouched surface deep black, so the pale engraving stands out more. On basswood it warms the wood and makes the burned tones richer, the same way it brings a cutting board back to life.
Food-grade matters once the project list grows: the same bottle finishes an engraved cutting board or a wooden spoon, which are the next gifts a laser owner usually makes.
Pro tip Slate can be oiled before or after engraving, and makers argue about which gives more contrast. Oil two spare coasters, one each way, engrave the same test image on both, and let the result decide for your stone and your laser. Wipe the excess off well either way; oil left on the surface collects dust.
Why we like it
Keep in mind
As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.
ACMER
Powder-coated tumblers on a roller rotary, names and logos on wood, leather and coated metal
Artliving
Displaying engraved coasters and small plaques, finishing the gift
ATOMSTACK
Cutting wood and acrylic on a diode laser that has an air-assist nozzle, cleaner engraving on wood
Brilliance Laser Inks
Bare or brushed stainless tumblers, flasks and tags on a diode or CO2 laser