Kraang Finds
More ▾
Products About
Electronics Kamoer

Kamoer NKP Peristaltic Pump (12 V)

A small pump that squeezes water along a tube — the water never touches the motor, and nothing flows when it stops.

DIY auto-topping pet water bowl with a sensor, clear reservoir and small pump, a cat drinking
Best for Auto-toppersplant wateringaquarium dosingmoving small amounts of liquid

A peristaltic pump moves water by squeezing a soft tube with rollers. For a pet bowl that design has two useful side effects: the water touches nothing but the tube, and when the motor stops, the rollers pinch the tube shut, so the reservoir can’t siphon into the bowl and flood the floor.

The slow flow is a feature here, too. A topper that adds water gradually gives the level sensor time to react, so it’s hard to overfill even if the code is a little slow to switch off.

Pro tip Time the pump into a measuring cup before you build it in. Knowing your real ml per minute lets you set a safe maximum run time: a little longer than one normal top-up, and no more.

Why we like it

  • ✓Water only touches the tube; no valves or seals inside the pump
  • ✓Self-priming, so the reservoir can sit beside or below the bowl
  • ✓Snap-in pump head comes off for tube replacement and cleaning
  • ✓Runs in either direction
  • ✓12 V DC, switches easily from a MOSFET module

Keep in mind

  • !Low flow, about 70 ml per minute — a large bowl takes several minutes to refill
  • !The pump tube wears with use and has to be replaced from time to time
  • !Audible motor hum while it runs
Voltage
12 V DC
Flow rate
≥ 70 ml/min
Tube
3 mm ID × 5 mm OD
Size
2.63 × 2.16 × 1.61 in
Weight
3.5 oz
Model
NKP-DC-S10B

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Electronics