Kraang Finds
More ▾
Products About
Laser Engraving KAITELA

KAITELA Clear Cast Acrylic Sheet, 5 × 7 in, 1/8 in, 10 Pack

Pre-cut 5 × 7 cast acrylic blanks with laser-cut edges and paper on both faces — the pane the photo gets frosted into.

A clear acrylic pane in a wooden LED base glowing with a frosted laser-engraved portrait of a dog, next to a phone showing the same photo
Best for Edge-lit photo night lightssmall acrylic signsa stack of blanks for test grids and spares

An edge-lit night light is a clear pane with a frosted picture in it, and the pane matters more than it looks. Acrylic comes two ways: extruded sheet, which engraves to a faint, clearish mark, and cast sheet, which turns a bright frosted white where the laser works. For a picture that has to glow, cast is the one. These are cast, and they come already cut to 5 × 7 with clean edges, which is the only way to get a tidy rectangle if your laser is a diode and can’t cut clear acrylic itself.

Ten in a pack sounds like a lot until the first evening: one gets the test grid, one gets the trial photo, and the third is the gift. The rest are the next three gifts.

Pro tip Peel the paper from one face only, the back, and paint and engrave that side with the front still covered. The front paper protects the viewing face from paint, scratches and fingerprints until the night light is finished.

Why we like it

  • ✓Cast acrylic, the kind that frosts to a brighter white under a laser than extruded sheet does
  • ✓5 × 7 in, a size that suits a head-and-shoulders portrait with a strip left over for the base slot
  • ✓1/8 in nominal (0.118 in / 3 mm), stiff enough to stand in a slot without flexing
  • ✓Laser-cut edges with no chips per KAITELA, and protective paper on both faces
  • ✓Ten in the pack — a test grid, a trial run, a mistake and still a few gifts

Keep in mind

  • !Pre-cut, so the rectangle is the shape; a diode laser can't cut clear acrylic into a different outline
  • !A clear pane shows every fingerprint, so it needs a careful clean before it goes in the box
  • !The paper has to come off the back before painting and off the front at the very end, and it tears if peeled fast
Size
5 × 7 in
Thickness
1/8 in nominal (0.118 in / 3 mm)
Material
Cast acrylic, clear
Edges
Laser-cut
Protective paper
Both sides
Count
10
Other sizes on the listing
4 × 6, 8 × 10, 8 × 12, 12 × 12, 12 × 16, 18 × 24 in
Model
A57CL10

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Laser Engraving