Kraang Finds
More ▾
Products About
Laser Engraving John Boos

John Boos Chop-N-Slice Maple Cutting Board

A flat, reversible edge-grain maple board with no juice groove — one face for the engraving, the other for the knife.

A maple cutting board laser-engraved with a family name and freshly oiled, with a raised open-frame laser engraver behind
Best for Engraved names and logospersonalized kitchen giftsserving and charcuterie boards

A cutting board is only as good a blank as its face is flat and plain. Maple is the usual choice for engraving because it’s pale and tight-grained: the laser darkens it to an even brown, and the letters don’t have to compete with bold grain lines. Edge grain also stays more stable than a glued-up end-grain checkerboard, which the laser would engrave in two different shades.

The Chop-N-Slice has no juice groove and two flat faces. That makes the design simple: the engraving goes on one side, which becomes the serving and display side, and the other face stays plain for everyday cutting.

Pro tip Only the design has to fit inside the laser’s working area, not the whole board. Before ordering, check that the board fits between the laser’s frame rails, or plan to raise the machine on blocks so the board slides under the frame. A 16 × 10 in board with a design about 8 in wide is the easy combination for most diode lasers.

Why we like it

  • ✓Hard maple, pale and fine-grained, so an engraving reads as a crisp dark brown
  • ✓Edge-grain construction with a flat face and no juice groove to work around in the design
  • ✓Reversible, so the engraved side can be the serving side and the other side takes the knife work
  • ✓Several sizes on one listing, from 10 × 5 in up to 20 × 15 in
  • ✓Made in the USA, with eased corners and an oil finish from the factory

Keep in mind

  • !The factory oil can darken unevenly under the laser — a test on the back corner comes first
  • !At 1–1.25 in thick it sits higher than a sheet of plywood, so the laser has to be raised or refocused
  • !The 20 × 15 in board is heavy (10 lb) and wider than most diode laser frames; 16 × 10 in is the easier size
Wood
Hard maple, edge grain
Sizes on the listing
10 × 5, 10 × 10, 16 × 10, 18 × 12, 20 × 15 in
Thickness
1–1.25 in (25–32 mm), depending on size
Juice groove
None, reversible
Care
Hand wash only
Made in
USA
Model
Chop-N-Slice (214 = 20 × 15 in)

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Laser Engraving