Kraang Finds
More ▾
Products About
3D Printing Honoson

Honoson Sanding Sticks, 20 Pieces, 80–12000 Grit

Thin, pointed sanding sticks for the edges and the ring hole of a small print — where a sheet of sandpaper can't reach.

A child's crayon drawing of a cat next to a 3D-printed keychain of the same cat in matching colors
Best for Keychain edges and holesminiaturessmall 3D printed parts

A printed keychain usually comes off the plate with one sharp spot: the first layer, which spreads a little and leaves a thin lip around the edge. That lip is what catches on pockets and scratches fingers. A few strokes with a sanding stick along the bottom edge take it off.

The pointed end also fits inside the ring hole, which is often the roughest part of the print. Smooth it so the jump ring turns freely and doesn’t wear through the plastic.

Pro tip Sand only the edges and the back. The top of a multicolor keychain is the drawing itself, and sanding it smears the colors and dulls the surface.

Why we like it

  • ✓Grits from coarse 80 to very fine 12000 in one set
  • ✓Each stick is labeled with its grit
  • ✓Thin, angled shape reaches into tight corners and small holes
  • ✓Use wet or dry

Keep in mind

  • !The finest grits polish rather than remove — on PLA you'll mostly use the lower half of the set
  • !Sticks wear down quickly on the coarse end
Pieces
20
Grit range
80–12000
Shape
Double angle
Use
Wet or dry
Model
YL-Honoson-2918

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More 3D Printing