Kraang Finds
More ▾
Products About
Electronics HiLetgo

HiLetgo ESP32 Development Board (ESP-WROOM-32)

A Wi-Fi board that runs WLED, so the panel gets a web page and phone app instead of a code editor.

A DIY pixel LED panel behind frosted acrylic showing a pixel Christmas tree and snowfall on a shelf, filmed by a phone on a tripod
Best for WLED controllersWi-Fi LED projectsArduino IDE projects that need Wi-Fi or Bluetooth

The classic ESP32 board is the default controller for WS2812B projects, mainly because of WLED: free firmware that gives the panel a web interface, more than a hundred effects, presets, schedules and a phone app. No code is needed to get a working panel.

Its pins run at 3.3 V while the panel expects 5 V data. That’s why this build adds a level shifter between the two.

Pro tip If the computer doesn’t see the board, try a different cable first. Many micro-USB cables from old chargers only carry power, not data.

Why we like it

  • ✓ESP-WROOM-32 module with dual-core processor, Wi-Fi and Bluetooth
  • ✓Programs from the Arduino IDE, or flashes WLED from a browser
  • ✓USB-to-serial chip on board; plug in and upload, no separate programmer
  • ✓Pin headers already soldered

Keep in mind

  • !Micro-USB, not USB-C, so you may need an older cable that carries data
  • !Wide board; on a standard breadboard it leaves only one row of holes free on one side
Module
ESP-WROOM-32
Wireless
Wi-Fi 2.4 GHz, Bluetooth
Logic level
3.3 V
USB
Micro-USB
Software
Arduino IDE, ESP-IDF, WLED

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Electronics