Kraang Finds
More ▾
Products About
3D Printing Gorilla

Gorilla Super Glue Gel XL, 25 g, Clear

A no-run cyanoacrylate gel for stacking the layers — it stays in a dot where you put it instead of flowing into the street channels.

A glowing layered 3D-printed city map night light in a black shadow box frame, with the unlit layers, acrylic sheet and LED strip for a second one on the bench
Best for Gluing PLA layers and printed spacerssmall repairs on printsmodel work

Stacking map layers is a lot of small glue joints in exactly the wrong place for liquid glue: next to open channels where a drop that runs ends up as a hard, shiny blob in a street. A gel stays as a dot. Put six or eight of them on the back of a layer, at the corners and across the wide land areas, press the next layer on, and in half a minute it holds.

The same gel fixes the four printed corner blocks inside the frame and the finished stack to the acrylic. The squeeze bottle gives small dots, and the pin in the cap means the bottle is still usable when the next project comes around, which with super glue is not a given.

Pro tip Align the layers dry first, mark two corners with a strip of masking tape, then glue. The gel sets in seconds, and a layer that lands 1 mm off doesn’t come apart again without breaking something.

Why we like it

  • ✓Gel stays put on flat and vertical surfaces — no run-off into cutouts
  • ✓Sets in 10–45 seconds without clamping, full cure in 24 hours, Gorilla says
  • ✓Anti-clog cap with a metal pin keeps the 25 g bottle usable for the next project
  • ✓Dries clear, with no foaming

Keep in mind

  • !Cyanoacrylate can leave a white haze (blooming) on plastic around the joint — keep it away from the translucent plate wherever light passes
  • !Bonds skin in seconds — keep the cap handy and a bottle of acetone within reach
Type
Cyanoacrylate gel
Size
25 g (0.88 fl oz)
Set time
10–45 s
Full cure
24 h
Finish
Clear
Model
112660

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More 3D Printing