Kraang Finds
More ▾
Products About
3D Printing ELEGOO

ELEGOO PETG Filament, 1.75 mm, 1 kg, Black

Tougher than PLA and less brittle under a sudden load — the usual material for printed brackets, clips and wall mounts.

A modular cat wall with pine steps on black 3D-printed brackets, carpet pads and a sisal-wrapped post, with a cat climbing
Best for Shelf bracketswall mountsclips and connectorsparts that take knocks

A printed cat-wall bracket has a harder job than most prints: it holds a board, and a few times a day a cat lands on that board from a jump. PLA is stiff but brittle, and it creeps under a constant load in a warm room. PETG is the usual step up. It gives a little before it breaks, and it holds its shape near a radiator or a sunny window.

A 1 kg spool covers a set of brackets, end caps and rope clips for a small wall, with spare for a test print or two. Black disappears in the shadow under a shelf; the same listing has lighter colors if your wall is white.

Pro tip Strength in a printed bracket comes from walls, not infill. Print load-bearing parts with 5–6 perimeters and lay them on the bed so the layers run along the arm of the bracket, not across it, so the load never tries to peel layers apart.

Why we like it

  • ✓PETG flexes a little before it cracks — better than PLA for a part a cat lands on
  • ✓Good layer adhesion, ELEGOO says — the weak point of any printed bracket
  • ✓±0.02 mm diameter tolerance; dried and vacuum sealed before packing
  • ✓Many colors on the same listing to match a wall or a wood tone

Keep in mind

  • !Strings more than PLA; expect to tune retraction or clean wisps off the parts
  • !Absorbs moisture once opened — dry it before a long batch of structural parts
Material
PETG
Color
Black
Diameter
1.75 mm ± 0.02 mm
Weight
1 kg
Part number
CA-EL-3D-PEB01

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More 3D Printing