Kraang Finds
More ▾
Products About
3D Printing ELEGOO

ELEGOO Mercury Plus 2.0 Wash and Cure Station

Washes the sticky resin off and cures the print with UV on a turntable — the step that turns a tacky print into a solid figure.

Photo of a dog on a phone, its 3D model on a laptop and the finished painted 3D printed figure of the same dog on a workbench
Best for Washing and curing resin printsany brand of resin printerfigures and miniatures

A resin print comes off the printer covered in liquid resin, soft and sticky. It needs two things before you can sand or paint it: a wash in alcohol to remove the uncured resin, and a UV cure to harden it all the way through. Doing that with a jar and sunlight works, but it’s messy and uneven.

The Mercury Plus does both steps in one machine. Wash the figure in the sealed bucket, swap to the curing turntable, and the UV lights cure it evenly from all sides. Since it isn’t tied to one brand, it works with the Anycubic printer above or most others.

Pro tip Don’t over-cure small figures. A few minutes is usually enough; too long can make thin parts brittle. Start short and check if the surface still feels tacky.

Why we like it

  • ✓Sealed wash container keeps the alcohol from evaporating
  • ✓16 UV LEDs (405 nm) and a 360° turntable for even curing
  • ✓Wash prints in a basket or still on the build plate
  • ✓Lid blocks 99.95% of UV light
  • ✓Works with most LCD, DLP and SLA printers

Keep in mind

  • !Not meant for washing water-washable resin — rinse that under running water
  • !You still need isopropyl alcohol for the wash bucket
Curing light
16 × 405 nm UV LEDs
Turntable
360° rotating
Wash
Sealed bucket, basket or build plate mount
Display
TFT, set and remaining time
Weight
10 lb

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More 3D Printing