Kraang Finds
More ▾
Products About
Electronics ELEGOO

ELEGOO 120pcs Dupont Jumper Wires (M-M, M-F, F-F)

Every connector type you need to go from board to driver to breadboard without soldering each test.

DIY Wi-Fi pet feeder with a 3D-printed base, clear food hopper and small camera dropping kibble into a bowl next to a cat
Best for Prototypingconnecting boards to drivers and sensorsbreadboard builds

Most of a feeder build is trial and error on the bench: which pins drive the motor, which way it turns, how many steps make a good portion. Jumper wires let you change the wiring in seconds instead of re-soldering. Female ends fit the ULN2003 driver’s header pins directly, and male ends go into a breadboard.

ELEGOO is clear that these are for low-voltage signal wiring, and that’s all a feeder needs: four control lines and the 5 V supply for a small stepper.

Pro tip Once the feeder works, put a drop of hot glue on each connector or wrap the bundle with a cable tie. A motor that shakes a little every feeding will eventually wiggle a loose jumper off its pin.

Why we like it

  • ✓40 each of male-male, male-female and female-female
  • ✓20 cm (8 in) leads, peel off one or a whole ribbon
  • ✓Standard 2.54 mm (0.1 in) pins fit breadboards and header pins
  • ✓Color-coded, so power, ground and signal are easy to tell apart

Keep in mind

  • !Copper-clad aluminum, not pure copper — fine for signals, not for heavy current
  • !Push-on connectors can work loose with vibration; secure them in the finished build
Pieces
120 (40 M-M, 40 M-F, 40 F-F)
Length
20 cm / 8 in
Pitch
2.54 mm / 0.1 in
Conductor
Copper-clad aluminum, PVC insulation
Model
EL-CP-004

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Electronics