Kraang Finds
More ▾
Products About
Electronics Ceksezx

Dual MOSFET Trigger Switch Module (6-Pack)

The switch between a 3.3 V board and a 12 V pump — one pin turns the pump on and off.

DIY auto-topping pet water bowl with a sensor, clear reservoir and small pump, a cat drinking
Best for Switching small pumpsfansLED strips and solenoids from a microcontroller

An ESP32 pin can’t power a 12 V pump directly; it can only tell something else to. A MOSFET module is that something: the board sends a 3.3 V signal, and the module connects the 12 V supply to the pump. It’s silent, has no moving parts and, unlike a relay, it can also run the pump at reduced speed with PWM.

Many common MOSFET modules (the IRF520 kind) don’t switch fully on at 3.3 V. This dual-MOSFET type is listed for 3.3 V logic, which is why it suits an ESP32.

Pro tip Put a diode (1N4007 or 1N5819) across the pump’s two terminals, with the striped end on the + wire. When the motor switches off it kicks back a voltage spike, and the diode absorbs it before it reaches the MOSFET.

Why we like it

  • ✓Takes a 3.3 V logic signal, so it works straight from an ESP32 pin
  • ✓Load side handles 5–36 V DC; the seller rates it at 15 A, far more than a small pump needs
  • ✓PWM up to 20 kHz if you want to slow the pump down
  • ✓Screw terminals for the power and pump wires
  • ✓Six in a pack, so there are spares for the next project

Keep in mind

  • !Unknown brand with little documentation; check the pin labels on your board before wiring
  • !No flyback diode visible on the board — add one across the pump's terminals
  • !Bare board; it needs a dry enclosure near water
Load voltage
5–36 V DC
Logic input
3.3–20 V
PWM
0–20 kHz
Rated current
15 A (seller rating)
Size
1.34 × 0.67 × 0.47 in
Pack
6 modules

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Electronics