Kraang Finds
More ▾
Products About
Electronics DAIERTEK

DAIERTEK 4 × AA Battery Holder with Switch and Cover

A closed 4 × AA box with an on/off switch and wire leads — the simplest battery pack for a prop.

Painted 3D-printed Halloween mask with a moving jaw on a workbench next to servos, an Arduino board and a battery box
Best for Battery packs for props and costumesservo powersmall DIY electronics

A loose battery holder with exposed cells is fine on a bench but not in a costume, where cells get knocked out and wires get pulled. A closed box with a screw-on lid and a switch solves both, and the switch lets you turn the mask off between photos without unplugging anything.

The leads are long enough to reach a connector on the costume but not long enough to reach up to the head; plan on an extension cable.

Pro tip Put a polarized plug (such as a JST or a servo-style connector) on the leads so the pack can’t be connected backwards, and add a small fuse or polyfuse in the red wire.

Why we like it

  • ✓Built-in ON/OFF switch on the back
  • ✓Screw-down cover keeps cells from falling out
  • ✓Wire leads about 150 mm (5.9 in) long, tinned ends
  • ✓68.7 × 64.2 × 22.5 mm — fits a pocket

Keep in mind

  • !Bare wire ends — you'll have to solder or crimp a connector on
  • !Labeled 6 V for alkaline cells; with NiMH it gives 4.8 V (which is what you want for servos)
Cells
4 × AA
Size
68.7 × 64.2 × 22.5 mm
Leads
~150 mm, tinned
Switch
ON/OFF
Cover
Screw-fastened

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Electronics