Kraang Finds
More ▾
Products About
Laser Engraving Creality

Creality Laser Engraver Enclosure (V1.0) with Exhaust Fan

A fabric tent with a tinted window and an exhaust fan that keeps smoke, smell and stray blue light inside the box.

A diode laser on a honeycomb bed with air assist, safety glasses, a rotary, an enclosure and engraving blanks on a workshop bench
Best for Diode lasers in a garagespare room or shared spacewhere smoke and smell need to go outside

Burning wood smells like a campfire; burning leather and acrylic smell a lot worse. An open-frame laser lets all of that into the room, and a desk fan only moves it around. An enclosure puts the laser in a tent and a small fan pulls the air out through a duct, so the smoke leaves the house instead of settling in it.

It also makes the machine safer for everyone else: the tinted window holds back most of the stray blue light, the cover keeps out pets and curious hands, and it collects the dust that would otherwise settle on the rails. Measure the outside of your laser’s frame, including any rotary or risers, before you order.

Pro tip Keep the duct run short and straight — every bend and every extra foot slows the airflow. And never leave a cutting job alone just because it’s under a cover; a fabric tent doesn’t stop a flare-up.

Why we like it

  • ✓700 x 720 x 400 mm (27.5 x 28.3 x 15.7 in) inside, tall enough for a rotary under the laser
  • ✓Exhaust fan and duct included, to pull smoke out through a window
  • ✓Large tinted window for watching the job without opening the cover
  • ✓Creality lists it for xTool D1/D1 Pro, Falcon, Ortur, Sculpfun and ATOMSTACK machines
  • ✓Fabric and frame pack down (about 5 lb) when not in use

Keep in mind

  • !The duct has to go outside to work — a window adapter or wall vent is up to you
  • !The window has no OD rating; Creality says it filters blue light, but wear rated glasses whenever the cover is open
  • !Fabric over a frame of tubes, not a rigid box — the pipe joints need care during assembly, per Creality
Inside size
700 x 720 x 400 mm (27.5 x 28.3 x 15.7 in)
Ventilation
Exhaust fan, duct and flange
Window
Tinted, front and top
Weight
5 lb
Model
Creality laser cover (V1.0)

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Laser Engraving