Kraang Finds
More ▾
Products About
Electronics Chemtronics

Chemtronics Soder-Wick Rosin SD Desoldering Braid 80-3-5

A flat copper braid with rosin flux that soaks up excess solder — the lightest way to undo a joint.

A portable USB-C soldering kit in an open pouch, repairing a string of fairy lights at a craft-fair booth
Best for Removing solder bridgesclearing padsundoing jointsportable kits

Every repair kit needs a way to take solder off as well as put it on. A desoldering pump is great on a bench, but it takes space in a small kit and needs a free hand to cock it. Braid does the same job on pads and bridges with nothing but the iron: lay it on the joint, press the tip on top, and the copper pulls the molten solder up into the weave.

Chemtronics’ Soder-Wick has the flux already in the braid, which is what makes it wick quickly instead of just sitting there.

Pro tip Use a clean section of braid every time and press with the flat side of the tip, not the point. Lift the braid and the iron together, so the braid doesn’t solder itself to the pad as it cools.

Why we like it

  • ✓Copper braid with rosin (RA) flux built in
  • ✓Size
  • ✓Comes on an ESD-safe static-dissipative bobbin
  • ✓Weighs next to nothing and fits in any pocket of a kit
  • ✓Works with leaded and lead-free solder

Keep in mind

  • !5 ft (1.5 m) goes quickly; the used end is cut off and thrown away
  • !Rosin flux leaves a residue that may need cleaning on a visible board
Material
Copper braid
Flux
Rosin activated (RA)
Size
#3, 2 mm (0.08 in) wide
Length
5 ft (1.5 m)
Bobbin
ESD-safe, static-dissipative
Model
80-3-5

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Electronics