Kraang Finds
More ▾
Products About
Electronics CanaKit

CanaKit 3.5A USB-C Power Supply (5 V)

A steady 5 V wall supply with a long USB-C cable — enough current for an ESP32 board, its camera and a small stepper at once.

DIY Wi-Fi pet feeder with a 3D-printed base, clear food hopper and small camera dropping kibble into a bowl next to a cat
Best for Powering ESP32 and Raspberry Pi projectsalways-on buildsfeeders and cameras

A Wi-Fi camera and a motor on the same small board make a power supply’s weaknesses obvious: the camera stream drops or the board resets when the motor starts. CanaKit made this supply for the Raspberry Pi 4, which is fussy about voltage, so it delivers a solid 5 V with current to spare for a much smaller ESP32 build.

The 5-foot cable lets the feeder sit away from the outlet. Run it along the wall and out of reach, because pets chew cables, and plan a battery or UPS option if your feeder has to keep working through short outages.

Pro tip Power the stepper driver from the XIAO’s 5V pin, which passes the USB supply straight through. One cable then feeds everything, and the grounds are already shared.

Why we like it

  • ✓Fixed 5 V at up to 3.5 A — plenty of headroom for a board, camera and stepper
  • ✓UL Listed
  • ✓5 ft cable with thick 18 AWG wire, so less voltage drop at the far end
  • ✓Built-in noise filter, CanaKit says

Keep in mind

  • !No battery backup — if the power goes out, so does the feeder
  • !Fixed USB-C plug; to feed a motor driver separately you need a USB-C breakout or to use the board's 5 V pin
Output
5 V DC, 3.5 A
Connector
USB-C
Cable
5 ft, 18 AWG
Plug
North American 2-pin
Certification
UL Listed

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Electronics