Kraang Finds
More ▾
Products About
Workshop XFasten

XFasten Double Sided Woodworking Tape, 1 in × 108 ft (3-Pack)

Cloth-backed double-sided tape that holds small, thin blanks flat where clamps would get in the way.

Desktop CNC router with a birch sheet of cut-out ornaments, finished carved ornaments, coasters and a small sign on the bench
Best for Holding thin sheets and small blanks on a CNCrouter templates

Clamps work for a single sign, but ornaments and coasters are small and thin: clamps take up space on the bed, sit in the way of the bit and can bow a 1/4 in sheet. Double-sided tape holds the sheet down across its whole surface, so it stays flat while the V-bit carves and the end mill cuts the shapes free.

This tape is made for that kind of job: router templates, CNC routing and holding boards to a carrier. A few strips across the back of a sheet are usually enough for light engraving passes.

Pro tip Wipe the dust off both the spoilboard and the back of the blank, lay the tape down, then press the blank on hard (a mallet over a scrap block works) or leave a weight on it for a minute. Tape holds by contact, and pressure makes the contact.

Why we like it

  • ✓Holds thin sheets flat across their whole face, not just at the edges
  • ✓No clamps in the toolpath, so the bit can reach the whole blank
  • ✓Cloth backing resists curling; XFasten says it peels off without residue
  • ✓Three 108 ft rolls — a long supply for small parts

Keep in mind

  • !Holds by surface contact, so dusty or rough stock won't stick well
  • !Small parts can still break loose on the final pass — leave tabs or a thin skin
Width
1 in
Length
108 ft per roll (3 rolls, 324 ft total)
Backing
Cloth
Adhesive
Silicone-based
Model
DSWT136P3

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Workshop