Kraang Finds
More ▾
Products About
Workshop 3M

3M 8511 N95 Cool Flow Valved Respirator (10-Pack)

A valved N95 for the dust no vac catches at the source.

A compact yellow shop vac and a low-profile cyclone on a clear bucket connected to a sander at a workbench in a closed winter garage
Best for Sandingsawingdrywallsweeping uplong sessions where a mask gets hot

A dust extractor on a sander catches most of the dust at the pad, but not all of it. Some escapes around the edges, some comes off the router bit in a spray, and some gets kicked back up when you sweep. In a closed garage that fine dust stays in the air for a long time, which is why a mask belongs in the kit next to the vac.

The 8511 is a disposable N95 with an exhalation valve. The valve lets warm breath out, so the mask stays cooler and your safety glasses fog less on a long sanding job.

Pro tip Do a quick seal check every time you put it on: cover the mask with both hands and breathe in sharply. It should pull in slightly against your face; if you feel air at the nose or edges, adjust the clip and straps.

Why we like it

  • ✓NIOSH-approved N95 for non-oil-based particles like wood and drywall dust
  • ✓Cool Flow exhalation valve; 3M says breathing is up to 50% easier than with its non-valved 8200
  • ✓Adjustable M-noseclip and braided headbands for a better seal
  • ✓Ten disposable masks, enough for a lot of sanding sessions

Keep in mind

  • !Disposable; it has to be replaced when it's dirty, damaged or harder to breathe through
  • !No protection against vapors from finishes or solvents; that needs a cartridge respirator
  • !Beards and stubble break the seal, as with any tight-fitting mask
Rating
NIOSH N95
Valve
3M Cool Flow exhalation valve
Count
10 respirators
Style
Disposable, cup shape
Model
8511

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Workshop