Kraang Finds
More ▾
Products About
Workshop 3M

3M VHB 5952 Double-Sided Mounting Tape, 1/2 in × 15 ft, Black

A thin black foam tape that bonds plastic, metal and painted surfaces for good — for the parts of a build that don't get a screw.

3D-printed motion-activated LED light bar stuck by magnets under a steel shelf, lighting a workbench with spare strip and magnets on it
Best for Fixing sensors and cable clips inside an enclosuresteel docking plates for magnetic toolspermanent mounting on metal and plastic

Not everything in a small enclosure deserves a screw. A motion sensor the size of a thumb, a cable that has to stay clear of the lid, a steel plate on a wooden shelf: these are jobs for a foam mounting tape. VHB is an acrylic foam with adhesive on both faces, and the foam gives enough to make full contact on surfaces that aren’t perfectly flat.

In this build it holds the sensor body and the cable runs inside the enclosure. It also gives the magnets somewhere to land where there’s no steel: tape a steel washer or a small plate to a wooden shelf and the light has a docking spot there.

Pro tip Wipe both surfaces with isopropyl alcohol, let them dry, then press the joint hard for several seconds. On a printed part, stick the tape to the smooth face that was on the print bed, not across the layer lines.

Why we like it

  • ✓Acrylic foam core conforms to surfaces that aren't perfectly flat
  • ✓Sticks to metal, plastic and painted surfaces, including most powder coats, per the listing
  • ✓Rated for service up to 250 °F
  • ✓A simple sizing rule from 3M — 4 sq in of tape for every pound of load
  • ✓1/2 in wide and 45 mil (1.1 mm) thick, so it fits narrow printed ledges

Keep in mind

  • !Permanent — not for anything you'll want to take apart or reposition
  • !Has to be applied between 50 and 100 °F; an unheated garage in winter is too cold
  • !Rough surfaces need more tape, 3M notes, and the layer lines on a print are a rough surface
Size
1/2 in × 15 ft (12.7 mm × 4.5 m)
Thickness
45 mil (1.1 mm)
Core
Closed-cell acrylic foam
Adhesive
Modified acrylic, both sides
Color
Black, red liner
Service temperature
Up to 250 °F
Application temperature
50–100 °F
Model
5952

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Workshop