Kraang Finds
More ▾
Products About
Woodworking WORKPRO

WORKPRO 12 in Quick-Release Bar Clamps, 2-Pack

Light one-handed bar clamps for holding a board down flat or a dam tight while epoxy cures.

A finished walnut live-edge charcuterie board with a turquoise epoxy inlay in a knot and crack, cheese and grapes on the wood
Best for Holding boards and epoxy dams in placesmall glue-upslight workshop clamping

Epoxy doesn’t need much clamping pressure, but it does need nothing to move for a day. These clamps hold a board down on a flat form, pull the side boards of a dam tight against the edge, and keep a thin board from lifting at a corner while the resin cures. The one-handed trigger matters here: the other hand is busy keeping the board in place.

At 150 lb, they’re on the light side, which suits this job and boards of this size. For gluing up a tabletop, a heavier clamp is the better tool.

Pro tip Put a strip of packing tape or a scrap of plastic under each clamp pad near the pour. Epoxy that drips onto a pad sets hard, and a clamp glued to a form is a frustrating start to demolding.

Why we like it

  • ✓One-handed squeeze trigger and a quick-release lever
  • ✓Up to 150 lb of clamping force, per WORKPRO
  • ✓Soft pads that don't dent walnut or mark the face of a board
  • ✓Jaws reverse to work as a spreader

Keep in mind

  • !Light duty — not for heavy glue-ups or pulling warped boards flat
  • !2-3/8 in throat depth limits how far in from the edge it can reach
  • !Two clamps is the minimum; a form board usually wants four
Opening
12 in (305 mm)
Throat depth
2-3/8 in
Clamping force
Up to 150 lb
Bar
Hardened steel, nylon-reinforced body
Pack
2 clamps

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Woodworking