Kraang Finds
More ▾
Products About
Woodworking Craftparts Direct

Craftparts Direct Wooden Axle Pegs, 1-1/4 in, 100 Pack

Round-head wooden axle pegs that hold a toy wheel and let it spin.

A hand-carved basswood pull toy car with treaded wooden wheels on a workbench, a child's hand holding its short cord and wooden handle
Best for Wooden toy carstrucks and trainswheels with a 1/4 in hole

An axle peg does two jobs. The shank is glued into a hole in the side of the car, and the wheel spins on the part between the car and the rounded head. Because the tenon is 7/32 in and the wheel hole is 1/4 in, the wheel turns freely while the peg stays put.

On a 2 in wide car body, a 1-1/4 in peg through a 1/2 in wheel leaves about 3/4 in in the wood on each side, so the holes from the two sides don’t meet in the middle. The rest of the pack is useful for the next car, or for pegs on a coat rack.

Pro tip Put the glue in the hole, not on the peg, and use only a little. Glue on the peg gets smeared into the wheel’s hole as you push it through, and the wheel ends up glued solid.

Why we like it

  • ✓Sized for wheels with a 1/4 in hole, like the treaded wheels in this build
  • ✓7/32 in tenon leaves the wheel spinning freely while the peg is glued in
  • ✓3/8 in rounded head keeps the wheel on with no hardware
  • ✓Sanded smooth and unfinished, so they take the same finish as the car

Keep in mind

  • !100 pegs is far more than one car needs
  • !Needs a 7/32 in drill bit, a size not every basic bit set includes
  • !Wood pegs can snap if a car is stepped on; check them before handing a toy on
Length
1-1/4 in (32 mm)
Tenon diameter
7/32 in (5.6 mm)
Head diameter
3/8 in (9.5 mm)
Fits
Wheels with a 1/4 in hole
Pack
100 pegs
Model
AP1005100

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Woodworking