3M
3M 8511 N95 Cool Flow Valved Respirator (10-Pack)
Sanding, sawing, drywall, sweeping up, long sessions where a mask gets hot
Starts the vac when the tool starts and stops it a few seconds after.
Dust collection fails in small ways. You start the sander, forget the vac, and the first minute of dust is already on the bench. Or you switch the tool off and walk away while the hose is still full of dust. An automatic switch takes both out of the loop: plug the tool and the vac into it, and the vac follows the tool.
The Ortis switch senses when the tool draws power, starts the vac a second later, and keeps it running for a few seconds after the tool stops, so the hose clears before it goes quiet. The threshold setting matters for small tools: a low-power palm sander may need the 30 W setting to trigger reliably.
Pro tip Add up the amps on the tool and vac labels before you plug both in. If they’re over 15 A together, run them on the switch with a smaller vac, or put them on separate circuits and switch the vac by hand.
Why we like it
Keep in mind
As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.
3M
Sanding, sawing, drywall, sweeping up, long sessions where a mask gets hot
3M
Fixing sensors and cable clips inside an enclosure, steel docking plates for magnetic tools, permanent mounting on metal and plastic
Anker
Laptops, phones, card readers, LED lights, USB-C rechargeable tools
Anker
Charging tool batteries away from an outlet, craft-market booths, job sites, outage backup