Kraang Finds
More ▾
Products About
Workshop IRWIN

IRWIN Quick-Grip One-Handed Mini Bar Clamps, 6-Pack (1964749)

Six one-handed clamps in three sizes — enough to glue up a ramp and hold a cube while you drill.

A handmade modular marble run of maple blocks and pine ramps on a workbench, a child's hand dropping a glass marble into the top
Best for Small glue-upsholding parts for drillingtoy and craft projects

Small projects still need clamps. A ramp is three thin strips glued together, and it only comes out straight if the rails are pressed down evenly along their whole length while the glue sets. The same clamps hold a block against a fence on the drill press, so your fingers are never the thing holding a small cube near a large bit.

The mixed pack suits that kind of work: the long clamps reach across a ramp, the short ones hold a cube in a jig, and all of them close with one hand.

Pro tip Lay a straight scrap of wood on top of a ramp’s rails and clamp through it, rather than clamping the rails directly. The scrap spreads the pressure, so a 12 in rail sits flat with three clamps instead of six.

Why we like it

  • ✓Three sizes in one pack, two each of 4-1/4, 6 and 12 in
  • ✓One-handed trigger leaves the other hand free to hold the parts
  • ✓Non-marring pads won't dent soft pine ramps
  • ✓Converts to a spreader by moving the jaw

Keep in mind

  • !Up to 140 lb of force is fine for small parts, not for big panel glue-ups
  • !Six clamps cover one long ramp at a time; more ramps means more waiting
Sizes
2 × 4-1/4 in, 2 × 6 in, 2 × 12 in
Clamping force
Up to 140 lb
Release
One-handed trigger
Model
1964749

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Workshop