Kraang Finds
More ▾
Products About
Woodworking INTOO

INTOO Hex Shank Forstner Bit Set, 16 Pieces

Sixteen flat-bottom bits from 1/4 to 2-1/8 in — the 3/4 in one bores every marble channel.

A handmade modular marble run of maple blocks and pine ramps on a workbench, a child's hand dropping a glass marble into the top
Best for Marble channelspeg holescups and pocketshinge and hardware recesses

Every opening in a block marble run is a round hole: a channel straight down, a channel out the side, a cup at the top to catch the marble, and small holes for the pegs that lock the blocks together. A Forstner set covers all of them with one kind of bit. Forstner bits cut a flat-bottomed, clean-walled hole, and they can bore two holes that meet inside a block, which is how a marble turns a corner.

For standard 16 mm (5/8 in) marbles, the 3/4 in bit leaves about 1/8 in of clearance, so the marble falls freely without rattling. The 3/8 in bit matches common dowel pins, and the 2-1/8 in bit makes a shallow funnel on a start block.

Pro tip Run large Forstner bits slowly and lift the bit every 1/4 in to clear the chips. In maple, chips packed in the hole are what heat the bit and leave burn marks on the channel walls.

Why we like it

  • ✓Sizes from 1/4 to 2-1/8 in, including 3/8 in for dowels and 3/4 in for 16 mm marbles
  • ✓Flat-bottomed holes with clean edges, which matters on the visible faces of a toy
  • ✓Hex shank on a 3/8 in reduced shank, so the bits don't slip in the chuck
  • ✓Wide sizes make starting cups and catch trays in one step

Keep in mind

  • !High-carbon steel dulls sooner than carbide in hard maple; keep speeds low
  • !Large sizes need a drill press and a clamped workpiece
Sizes
1/4, 3/8, 1/2, 5/8, 3/4, 7/8, 1 in, then 1/8 in steps to 2-1/8 in
Pieces
16
Material
High-carbon steel
Shank
3/8 in, hex

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Woodworking