Kraang Finds Products About
Electronics Eventronic

Eventronic 900-Piece Heat Shrink Tubing Kit, 2:1

Twelve sizes of heat shrink in one box — a clean, insulated finish for every splice instead of electrical tape.

Best for Insulating solder spliceswire repairscable endsstrain relief on connectors

Electrical tape on a splice looks fine for a week, then the adhesive goes gummy and the tape unwinds. Heat shrink tubing is the proper way to insulate a soldered joint: slide a piece over the wire before you solder, push it over the joint afterwards, and shrink it tight with heat.

The catch is always having the right size on hand. This kit has 12 sizes sorted in one box, from thin 1 mm tubing for small signal wires to 13 mm for thick cables and bundles.

Pro tip Slide the tubing onto the wire before you solder, and keep it well away from the joint while it cools. It’s easy to finish a perfect joint and only then notice the tubing still on the table.

Why we like it

  • ✓900 pieces in 12 sizes, from 1 mm to 13 mm
  • ✓Polyolefin, shrinks to half its size (2:1)
  • ✓Sorted in a plastic box with compartments
  • ✓Cleaner and longer-lasting than electrical tape

Keep in mind

  • !45 mm pieces — longer joints need tubing from a roll
  • !For outdoor or car wiring that has to stay sealed, use adhesive-lined 3:1 tubing
Pieces
900
Sizes
12 (1–13 mm)
Shrink ratio
2:1
Material
Polyolefin
Piece length
45 mm (1.77 in)
Box
Plastic, compartments

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Electronics