3M
3M 8511 N95 Cool Flow Valved Respirator (10-Pack)
Sanding, sawing, drywall, sweeping up, long sessions where a mask gets hot
Short black wood screws for fixing boards to printed brackets — long enough to bite, short enough not to poke through.
Every printed bracket has two jobs: hold on to the wall and hold on to the board. These screws are for the second. A #8 × 1-1/4 in flat-head screw goes through a typical printed bracket arm and well into a thick board without coming out of the top, and the black finish stays out of sight under the shelf.
Design or choose brackets with countersunk holes, so the screw head sits flush and pulls the plastic down evenly instead of cracking it. Drive the last turn by hand; a drill on full torque can split a print.
Pro tip Drill a small pilot hole in the board (about 1/8 in for #8 in pine). The screw then pulls the bracket tight to the board instead of pushing the two apart.
Why we like it
Keep in mind
As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.
3M
Sanding, sawing, drywall, sweeping up, long sessions where a mask gets hot
3M
Fixing sensors and cable clips inside an enclosure, steel docking plates for magnetic tools, permanent mounting on metal and plastic
Anker
Laptops, phones, card readers, LED lights, USB-C rechargeable tools
Anker
Charging tool batteries away from an outlet, craft-market booths, job sites, outage backup