Kraang Finds
More ▾
Products About
3D Printing Capricorn

Capricorn XS Series PTFE Bowden Tubing, 1 m

A low-friction tube that carries filament from a sealed box to the printer without exposing it.

3D printer printing from a sealed filament dry box, with stored spools in clear boxes and a hygrometer on a rainy evening
Best for Feeding filament from a dry boxreplacing a Bowden tube1.75 mm printers

A dry box helps most when the filament stays covered all the way to the printer. A PTFE tube from the box’s feed port to the extruder keeps the strand out of room air and guides it without snagging, so you can print straight from a sealed box.

Capricorn’s XS tubing has a tighter inner diameter than generic PTFE, which leaves less room for the filament to wiggle. That’s why it’s also a popular replacement for the Bowden tube itself.

Pro tip Route the tube in a gentle curve with no sharp bends. Every tight bend adds drag that the extruder has to pull against, and that can show up as under-extrusion on long prints.

Why we like it

  • ✓Tight 1.95 mm inner diameter for 1.75 mm filament
  • ✓Standard 4 mm outer diameter fits common push-fit couplers
  • ✓Low-friction PTFE — filament slides easily over a longer run
  • ✓1 m is enough to run from a box on the shelf to the extruder

Keep in mind

  • !1.75 mm filament only
  • !No fittings in this listing — couplers are bought separately
Length
1 m (3.3 ft)
Inner diameter
1.95 mm ± 0.05 mm
Outer diameter
4.0 mm
Filament
1.75 mm
Material
PTFE

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More 3D Printing