Kraang Finds
More ▾
Products About
Workshop VGBUY

VGBUY M3 Socket Head Screw Assortment, 304 Stainless Steel, 600 Pieces

Eight lengths of M3 socket head screws with nuts and washers in one labeled box — the standard fastener for 3D-printed enclosures.

3D-printed motion-activated LED light bar stuck by magnets under a steel shelf, lighting a workbench with spare strip and magnets on it
Best for Closing printed enclosuresjoining multi-part printssmall electronics mounts

Glue makes an enclosure you can’t open again, and a battery-powered light is something you will open: to swap the pack, move the sensor or replace a strip. M3 is the standard screw size for small 3D-printed parts, and a socket head can be driven with a hex key down in a recess where a screwdriver won’t reach.

An assortment makes sense here because you rarely know the right length until the parts are printed. Short screws close the lid; the 25 and 30 mm ones go through two sections of a long light bar and into a nut on the far side.

Pro tip Model a hexagonal pocket for each nut (5.5 mm across the flats for M3, plus a little clearance) instead of driving screws straight into the plastic. A trapped nut can be opened and closed as often as you like; a thread cut into a print wears a little every time.

Why we like it

  • ✓Eight lengths from 6 to 30 mm, so one box covers lids, joints and stacked parts
  • ✓Matching nuts, flat washers and lock washers included
  • ✓304 stainless steel, which resists rust in a damp garage
  • ✓Labeled box with separate compartments

Keep in mind

  • !Only 15–20 screws of each length, so one size can run out fast on a big project
  • !Socket cap heads only — no countersunk or button heads in this version
  • !No heat-set inserts; you thread into plastic or trap the nuts in printed pockets
Thread
M3 × 0.5
Lengths
6, 8, 10, 12, 16, 20, 25, 30 mm
Screws
150 (20 each up to 20 mm, 15 each of 25 and 30 mm)
Also in the box
Hex nuts, flat washers, lock washers
Head
Hex socket cap
Material
304 stainless steel

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Workshop