Akro-Mils
Akro-Mils 10116 16-Drawer Storage Cabinet
Screws and nuts at the desk, electronic components, beads and craft parts, spare 3D printer parts
A 7-inch IPS touchscreen with mounting holes for the Pi on its back — the screen and computer become one slab.
A cyberdeck lives or dies by its screen. It sets the size of the case, the power budget and how usable the whole thing is. Seven inches is the common sweet spot: big enough for a terminal and a browser, small enough to carry in a bag. This one is made for the Pi, with four mounting holes on the back so the board bolts on behind the panel.
Touch works over the same micro USB cable that powers the screen, so on Raspberry Pi OS there’s nothing to install. Plan the cable route early: a right-angle micro HDMI cable from the Pi to the screen keeps the back of the deck flat and stops the plug from straining the connector.
Pro tip Peel off the factory screen protector before you fit the panel into the case. The listing says touch responds better without it, and it’s much harder to remove once the bezel is on.
Why we like it
Keep in mind
As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.
Akro-Mils
Screws and nuts at the desk, electronic components, beads and craft parts, spare 3D printer parts
Akro-Mils
Screws and nuts, electronic components, 3D printer spare parts, small craft supplies
Akro-Mils
Wall above the bench, bulk screws and fasteners, filament spares and nozzles, kit parts by project
Anker
First cyberdeck, portable Pi builds, anything that runs on USB-C power