Kraang Finds
More ▾
Products About
Maker Gear OLFA

OLFA 45mm Quick-Change Rotary Cutter (RTY-2/C), Aqua

Rolls through fabric, felt, leather and foam in one straight pass, where a knife would drag.

A maker bench with a cutting mat, hobby knife, steel ruler, rotary cutter, snap-off knife and flush cutters
Best for Cutting fabric and feltthin leather and craft foamlong straight strips against a ruler

A knife pulls fabric, felt and foam as it cuts, so long cuts go wavy. A rotary cutter rolls instead of dragging: the blade presses straight down and travels along the ruler, which gives clean, square edges on cosplay foam, felt, leather strips and fabric.

The RTY-2/C is OLFA’s 45 mm quick-change cutter, the standard size for most craft work. The quick-change system means the blade comes out without a pile of tiny parts, which makes it more likely you’ll actually swap a dull one.

Pro tip Close the blade cover after every single cut, even if you’re about to make another one. A rotary blade is exposed on all sides, and most injuries happen when an open cutter is set down on the bench.

Why we like it

  • ✓45 mm tungsten tool steel blade (RB45) comes installed
  • ✓Quick-change system for faster, safer blade swaps
  • ✓Built-in blade cover slides over the edge between cuts
  • ✓Contoured handle with finger grooves; works left- or right-handed
  • ✓OLFA says it cuts up to 8 layers of cotton fabric

Keep in mind

  • !Blade cover is manual — you have to remember to close it every time
  • !Needs a cutting mat; on a bare bench it dulls the blade almost instantly
Model
RTY-2/C
Blade
45 mm RB45, tungsten tool steel
Handle
Plastic, finger grooves, hang hole
Hand
Left or right
Cuts
Fleece, felt, wool, cotton, leather, suede, foam, vinyl
Weight
1.6 oz

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Maker Gear