Kraang Finds
More ▾
Products About
Workshop Neosmuk

Neosmuk Countersunk Neodymium Cup Magnets with Screws, 10-Pack

Small screw-on cup magnets that turn the back of a printed enclosure into something that sticks to any steel surface.

3D-printed motion-activated LED light bar stuck by magnets under a steel shelf, lighting a workbench with spare strip and magnets on it
Best for Magnetic backs for DIY lights and tool holdersjigscabinet and shop fixtures

Magnets are what make a work light useful: stuck to a hood, a drill press column or a steel shelf, the light points where you need it and both hands stay free. Cup magnets with a countersunk hole are the easy kind to add to a printed part. One screw through the center holds each magnet, and the steel cup directs the pull toward the face that touches the metal.

Four at the corners of a small light leave six spares for the next project. They’re strong for their size, so keep them apart while you work: two that snap together can pinch skin and chip.

Pro tip Model a shallow recess for each magnet so it sits about half a millimeter proud of the enclosure’s back. The magnets then touch the steel first, and the plastic never holds them off the surface.

Why we like it

  • ✓Countersunk center hole, so the screw head sits flush with the magnet face
  • ✓Steel cup concentrates the pull on the contact face
  • ✓0.67 in (17 mm) across and 0.2 in (5 mm) thick — easy to recess into a printed part
  • ✓Ten magnets with screws; nickel-copper-nickel plating against rust

Keep in mind

  • !"Up to 22 lb" is a straight pull on thick, clean steel — expect far less on thin sheet metal, over paint or against sliding
  • !The listing doesn't give the screw size or length
  • !Bare metal faces can scratch a painted surface
Quantity
10 magnets with screws
Diameter
0.67 in (17 mm)
Thickness
0.2 in (5 mm)
Pull
Up to 22 lb each, Neosmuk says
Construction
Neodymium in a steel cup
Coating
Ni-Cu-Ni

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Workshop