Kraang Finds
More ▾
Products About
DIY Mill-Rose

Mill-Rose 70660 Blue Monster PTFE Thread Seal Tape, 1/2 in x 260 in

A few wraps on the threads and a leaky shower arm or hose fitting stops dripping.

Hands wrapping blue thread seal tape around the threads of a shower arm
Best for Shower armsthreaded pipe fittingshose bibswater and oil lines

Threaded pipe joints don’t seal on metal alone. The threads leave tiny spiral gaps, and water finds them. Thread seal tape fills those gaps and lubricates the threads so the joint can be tightened fully. It’s the fix for the classic drip where a shower arm goes into the wall or a hose bib connects to a pipe.

The Blue Monster is a well-known plumber’s version of the tape, on a 260-inch roll. For joints that keep weeping, many plumbers wrap the tape and then add a thin coat of pipe thread sealant (pipe dope) on top.

Pro tip Wrap clockwise when you’re looking at the end of the pipe — the same direction the fitting turns on — so tightening smooths the tape down instead of unrolling it. Three to four wraps is plenty; keep it off the first thread.

Why we like it

  • ✓PTFE fills the gaps between threads so the joint seals
  • ✓Rated from -450 to +500 °F (-268 to +260 °C)
  • ✓Mill-Rose says it has been used on fittings at up to 10,000 PSI
  • ✓260 in (6.6 m) roll covers a lot of small fittings

Keep in mind

  • !Not for oxygen lines (Mill-Rose warns against it)
  • !Gas lines call for gas-rated (yellow) tape — this isn't it
  • !Only for tapered pipe threads, not compression fittings or flare joints
Width
1/2 in (12.7 mm)
Length
260 in (6.6 m)
Material
PTFE
Temperature
-450 to +500 °F
Model
70660

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More DIY