Kraang Finds
More ▾
Products About
Maker Gear KNIPEX

KNIPEX 78 03 125 Electronics Super Knips, 5-Inch

Flush cuts on wire leads, zip ties and plastic sprues, with fine tips that reach right up to the part.

A maker bench with a cutting mat, hobby knife, steel ruler, rotary cutter, snap-off knife and flush cutters
Best for Trimming component leadscutting zip ties flushsnipping model sprues and fine wire

Flush cutters are the snips of the maker bench: component leads after soldering, the tail of a zip tie, sprues on a model kit, a stray support on a print. A flush cutter leaves a flat end instead of a pinched point, so there’s nothing sharp left sticking out.

The Super Knips is KNIPEX’s fine electronics cutter, with an opening spring and narrow tips that slip between parts on a crowded board. It’s a precision tool, so it lives in the drawer for fine work, not for hardware store wire.

Pro tip Wear glasses when trimming leads, and cover the cut end with a finger. Short copper offcuts fly surprisingly far, and they always seem to find an eye or the inside of a power supply.

Why we like it

  • ✓Ground cutting edges with no bevel, for a truly flush cut
  • ✓Precision tips cut close-sitting wire down to 0.2 mm
  • ✓Opening spring with restricted opening, so it stays in your hand
  • ✓Smooth joint designed to reduce hand fatigue, per KNIPEX

Keep in mind

  • !For soft copper wire and plastic only — piano wire or screws will chip the edges
  • !The fine tips are easy to spring if you twist while cutting
Model
78 03 125
Length
5 in (approx. 5.1 in)
Cut
Flush, no bevel
Capacity
Up to 1.6 mm soft wire
Edge hardness
Approx. 54 HRC
Standard
DIN ISO 9654
Weight
2.1 oz

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Maker Gear