Kraang Finds
More ▾
Products About
Maker Gear eSUN

eSUN PLA+ (PLA PRO) Filament, 1.75 mm, 1 kg, Black

A tougher PLA for the shell — prints as easily as regular PLA, with clips and screw bosses less likely to snap.

A homemade black Raspberry Pi cyberdeck with a 7-inch screen and mini keyboard on a maker desk
Best for Printed enclosures and casesfunctional partssnap-fit lids

The case is where a cyberdeck gets its personality, and most builders print it. There are free cyberdeck shell designs on Printables, Thingiverse and MakerWorld, sized for 7-inch screens and the Pi. PLA+ is a good material for them: as easy to print as plain PLA, but less brittle, so screw bosses and snap-fit lids survive being opened again and again.

A 1 kg spool is enough for a full shell and several test prints. If you want a two-tone deck, the same line comes in over twenty colors with the same print settings.

Pro tip Print the screw posts with four walls or more and use M2.5 heat-set inserts instead of screwing straight into the plastic. The case will survive being opened dozens of times.

Why we like it

  • ✓1.75 mm with ±0.03 mm diameter tolerance, eSUN says
  • ✓Prints at 205–225 °C on any common FDM printer
  • ✓Vacuum-sealed with desiccant
  • ✓Over 20 colors in the same line, for two-tone cases

Keep in mind

  • !Still PLA — it softens in a hot car, so don't leave the deck on a sunny dashboard
  • !Black hides layer lines but also shows dust and fingerprints
  • !Absorbs moisture once opened — store it sealed, or prints turn stringy
Material
PLA+ (PLA PRO)
Diameter
1.75 mm ± 0.03 mm
Weight
1 kg (2.2 lb)
Nozzle temp
205–225 °C
Spool
8 in diameter, 2.5 in wide, 2.05 in hub hole
Part number
IG-C-PLAPRO175B1

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Maker Gear