Kraang Finds
More ▾
Products About
Maker Gear Duco Plastics & Supply

Duco Clear Cast Acrylic Sheet, 1/8 in, 12 × 24 in

A clear backing panel that disappears on the wall, so the glowing letters seem to float.

Warm-white DIY neon rope sign glowing on a clear acrylic panel above a shelf, with neon tube and remote on a table
Best for Neon sign backing boardsdisplay panelslaser-cut and engraved signs

A clear back panel is the standard way to build a neon-style sign at home: the light tube is tied to the front, the wiring runs behind, and on the wall the panel almost vanishes. Cast acrylic is the better choice for this, because a drill bit tends to grab and crack extruded sheet more easily.

The protective paper is the other reason it works well for a first sign. You can print or trace the lettering, tape it on, mark every hole, and drill through the paper while it protects the surface from scratches.

Pro tip Drill acrylic with the sheet clamped flat on scrap wood, at low speed and light pressure. Start with a small pilot hole, and slow down just before the bit breaks through, when chips are most likely.

Why we like it

  • ✓Cast acrylic, which drills and laser-cuts more cleanly than extruded sheet, per the listing
  • ✓Protective paper on both sides — draw the layout and drill right through it
  • ✓12 × 24 in fits a short name or word; other sizes are on the same listing
  • ✓UV-stable for long-term clarity, Duco says

Keep in mind

  • !Real size is a little under nominal (about 11 7/8 × 23 7/8 in), with ±1/8 in cut tolerance
  • !1/8 in is thin; a long sign can flex when you hang it from two points
  • !Scratches easily once the paper is off
Material
Cast acrylic
Thickness
1/8 in (3 mm)
Size
12 × 24 in nominal
Color
Clear
Pack
1 sheet

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Maker Gear