Kraang Finds
More ▾
Products About
Maker Gear Tamiya

Tamiya 74112 Fine Pin Vise D-R (0.1–3.2 mm)

A hand drill you turn with your fingertips — for holes too small or too delicate for anything with a motor.

Maker bench with a rotary tool, pin vise, needle files, precision driver kit and mini clamps on a cutting mat
Best for Pinning miniaturesdrilling model kitsclearing small holes in printsjewelry and resin work

A 0.5 mm hole in a miniature’s wrist or a model’s antenna mount is too small and too delicate for a power tool. A pin vise is just a chuck on a handle: rest the cap in your palm, twist the body with your fingers, and the bit cuts as slowly as you want. Plastic and resin don’t melt, and thin parts don’t crack from a bit that catches.

Tamiya’s fine version takes bits from 0.1 to 3.2 mm, which covers everything from pinning brass rod in a figure to opening up a clogged hole in a print. The cap spins on a ball bearing, so it stays put while the body turns.

Pro tip Mark the spot with a sharp hobby knife point first, so a tiny bit doesn’t walk. Back the bit out every few turns to clear the chips — micro bits break when they clog, not when you push.

Why we like it

  • ✓Holds bits from 0.1 to 3.2 mm
  • ✓Ball-bearing swivel cap, so the top stays still under your palm while the body turns
  • ✓Nickel-plated brass body with a rubbery elastomer grip
  • ✓No heat and no speed — a bit can't grab and spin the part out of your hand

Keep in mind

  • !Drill bits are not included — buy a set of micro bits with it
  • !Slow by design; for more than a few holes, a rotary tool is faster
Bit range
0.1–3.2 mm
Cap
Ball-bearing swivel
Body
Nickel-plated brass, elastomer grip
Weight
1.44 oz (41 g)
Model
74112

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Maker Gear