Kraang Finds
More ▾
Products About
Pet Gadgets Inkbird

Inkbird ITC-308 Temperature Controller

A plug-in thermostat — the pad plugs into its heating socket, the probe goes under the cover, and it cuts the power the moment the surface reaches the number you set.

A cat asleep on a DIY heated pet bed with a gray fleece cover, a plug-in thermostat glowing on the wall above it
Best for Controlling a heating pad from the real surface temperaturea high-temperature alarmany plug-in heater up to 1100 W

A pet pad’s own thermostat measures the pad. What matters is the surface your animal lies on, under the cover, and that is what this controller measures. The pad plugs into its heating socket, the probe is taped on top of the pad, and the controller switches the pad off at the temperature you set and on again when the surface drops by the differential you choose.

It’s the same box home brewers and reptile keepers use, which is why it has a buzzer. Set a high alarm a few degrees above the set point and a low alarm a few degrees below it, and it tells you when something is off: a pad running away, or a probe that slipped out of the bed and is reading the room.

Pro tip Hang it on the wall by the slot at the top, at a height where you can read the display from the sofa and the pet can’t reach it. A controller lying on the floor behind the bed is one you’ll stop looking at.

Why we like it

  • ✓Plug-and-play: wall plug on one end, heating and cooling sockets on the other, probe included
  • ✓Shows measured and set temperature at the same time, in °F or °C
  • ✓Buzzer alarm for high or low temperature and for a probe fault
  • ✓Switches up to 1100 W at 110 V, far more than a pet pad draws
  • ✓Dual relay: the cooling socket can run a fan for the same bed in summer

Keep in mind

  • !The probe reads one spot; it has to sit where the pet lies, not at the edge of the bed
  • !Setup is three buttons and a few two-letter menu codes; keep the manual for the first evening
  • !This link is the non-Wi-Fi version; the Wi-Fi variant is a separate listing
Load
1100 W max at 110 V
Outputs
Heating socket + cooling socket (dual relay)
Display
Dual window, measured + set temperature, °F/°C
Alarm
High/low temperature, sensor fault
Probe
Included
Size
5.51 × 2.68 × 1.3 in
Weight
1.1 lb

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Pet Gadgets