Kraang Finds
More ▾
Products About
Maker Gear Gorilla

Gorilla 2-Part Epoxy, Clear, 0.85 oz Syringe, 2-Pack

Clear, gap-filling two-part epoxy that sets in five minutes — for the broken mug handle, the loose metal bracket and the part super glue can't hold.

Maker workbench with a chair clamped for repair and a hot glue gun, accelerator spray, epoxy syringe, UV pen and glue injector laid out
Best for Rebuilding broken partsbonding metal and ceramicfilling gapsrepairs that carry load

Super glue holds a clean break on a small part. It doesn’t hold a mug handle, a metal bracket with a gap behind it, or anything that will be pulled on later. For those, a two-part epoxy is the repair that stays repaired: it fills the gap, cures hard and carries load.

The five-minute set time is the useful middle. Long enough to push out equal beads, mix on a scrap of cardboard, spread it and line up the parts; short enough that you can let go after a few minutes instead of clamping overnight. Clear means a repair on a visible edge doesn’t show as a gray seam.

Pro tip Push the plunger slowly so both barrels come out in equal lengths; an uneven mix stays tacky. Mix for a full minute with a stick until it’s one clear mass, and tape the parts instead of holding them for the five minutes. Rough up smooth surfaces with sandpaper first — epoxy grips texture, not shine.

Why we like it

  • ✓Sets in 5 minutes, with time to reposition; full cure in 24 hours
  • ✓Fills gaps and bonds uneven or vertical surfaces, so broken edges don't have to match perfectly
  • ✓Dries clear; Gorilla rates it at 3,300 psi tensile strength
  • ✓Water resistant once cured
  • ✓Dual syringe keeps resin and hardener apart, with a cap so one syringe lasts several repairs

Keep in mind

  • !Five minutes means mixing only what you'll use right away; the rest hardens on the mixing card
  • !Rigid when cured — not for parts that flex, and like most epoxies it won't bond polyethylene or polypropylene (bins, bottle caps)
  • !The syringe tip crusts over after the first use; wipe it and cap it immediately
Type
Two-part epoxy
Size
0.85 fl oz (25 ml) per syringe, 2 syringes
Set time
5 min
Full cure
24 h
Tensile strength
3,300 psi (Gorilla)
Finish
Clear
Water resistance
Water resistant
Model
4200101-2

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Maker Gear